Honda All New Amaze 2018 Manual, Page 258

256
Maintenance
Replacing Light Bulbs
Headlight Bulbs
When replacing, use the following bulbs.
1. Remove the coupler.
u It can be removed by pulling it straight
back.
2. Remove the rubber weather seal.
3. Unclip the hold-down wire, then pivot it out
of the way.
4. Remove the old bulb.
5. Insert a new bulb into the headlight
assembly.
6. Clip the hold-down wire properly.
7. Install the rubber weather seal.
8. Insert the coupler into the connector of the
bulb.
High/Low beam headlight: 60/55 W (H4 for halogen bulb type)
■
High/Low Beam Headlight
1
Headlight Bulbs
NOTICE
Halogen bulbs get very hot when lit.
Oil, perspiration, or a scratch on the glass can cause
the bulb to overheat and shatter.
The headlight aim is set by the factory, and does not
need to be adjusted. However, if you regularly carry
heavy items in the boot, have the aiming readjusted
at a dealer or by a qualified technician.
When replacing a halogen bulb, handle it by its base,
and protect the glass from contact with your skin or
hard objects. If you touch the glass, clean it with
denatured alcohol and a clean cloth.
Weather Seal
Coupler
1High/Low Beam Headlight
Make sure the hold-down wire is installed properly
and securely.
Check its installation from the inspection window.
Hold-down Wire
Hold-down Wire
Bulb
2UA_Manual_ 30-03-18.indd 259 4/5/2018 3:05:31 PM